Device Description - Dreve Labormat SD Mode D'emploi

Labormat SD, TH

1. Device description

Labormat devices are boil-out and poly-
merisation devices with a water tank
which can be pre-heated continuously
from 30–95 °C. The pump and spray
tube system facilitates specific clean-
ing of plaster models, for example,
as well as the extraction of wax com-
ponents using flask technology.
The freely-accessible water tank also
permits temperature-controlled long-
term polymerisation of hot-polymer-
ising resins.
2. Technical data
Labormat SD
Nominal voltage:
Nominal frequency:
Output:
Operating temperature:
Max. water volume:
Dimensions (H x W x D):
Weight:
Labormat TH
Nominal voltage:
Nominal frequency:
Output:
Operating temperature:
Max. water volume:
Dimensions (H x W x D):
Weight:
38
Both device models feature an over-
heating protection function which is
automatically triggered in the event
of a water shortage.
Labormat SD:
Large standalone device with an approx.
capacity of 50 litres and accommodat-
ing up to 12 flasks.
Labormat TH:
Small tabletop device with an approx.
capacity of 15 litres and accommodat-
ing up to 6 flasks.
230 V~ / 220 V~
50 Hz / 60 Hz
3100 W
30–95 °C
50 l
850 x 630 x 600 mm
75 kg
230 V~ / 220 V~
50 Hz / 60 Hz
3200 W
30–95 °C
15.0 l
440 x 580 x 360 mm
38 kg
3. Commissioning
Prior to commissioning, please Establish a mains connection with the
ensure that the mains voltage indi- mains cable. Fill the device with water
cated on the rating plate complies (please refer to the section „Filling with
with the voltage supplied by the water").
power source.
39