Dyna-Glo DGP321SNP Mode D'emploi page 24

CARE AND MAINTENANCE
Burner Assembly
Removing The Burner Assembly
1. Make sure all control knobs are in the OFF
position, gas supply valve is closed, and the
gas hose is disconnected from the gas supply.
2. Open lid and remove warming rack, cooking
grates, and heat tents.
3. Remove hinge pin as illustrated in Figure 1.
4. Slide main burners out of firebox.
5. Detach ignition wire from electrode in Figure 2.
Figure 1
Figure 1
Warming Rack
Cooking Grates
Heat Tents
Figure 2
Figure 2
24
Warming Rack
Cooking Grates
Heat Tents