Operating In Other Conditions - Yamaha F200 Manuel De L'utilisateur

2. Slightly tilt the outboard motor up to the
desired position using the power trim
and tilt switch. WARNING! Using the
power trim and tilt switch on the bot-
tom cowling while the boat is moving
or engine is on could increase the risk
of falling overboard and could distract
the operator, increasing the risk of
collision with another boat or an ob-
stacle.
[EWM01851]
3. To return the outboard motor to the nor-
mal running position, press the power
trim and tilt switch and slowly tilt the out-
board motor down.
EMU41371

Operating in other conditions

Operating in salt water
After operating in saltwater, brackish water,
or water high in other minerals, flush the cool-
ing system with fresh water to minimize cor-
rosion and clogging of the cooling water
passages with deposits. Also, rinse the exte-
rior of the outboard motor with fresh water.
Operating in water containing mud, sand,
silt, debris, or vegetation
Mud, sand, silt, debris, and vegetation in the
water may restrict water flow into the cooling
water inlet covers or clog internal water pas-
sages. Check and clean the cooling water in-
let covers frequently when operating in these
conditions. Flush the engine with clean, fresh
water after use in these environments. Con-
N
ZMU05829
sult your dealer if normal water flow can not
be restored by cleaning the cooling water in-
let covers or flushing with fresh water.
Operation
72