Tilting Up And Down; Procedure For Tilting Up (Power Trim And Tilt Models) - Yamaha F200 Manuel De L'utilisateur

Operation
the bow is greatly increased, heightening the
danger of "bow steering" and making opera-
tion difficult and dangerous.
TIP:
Depending on the type of boat, the outboard
motor trim angle may have little effect on the
trim of the boat when operating.
EMU27948

Tilting up and down

If the engine will be stopped for some time or
if the boat is moored in shallows, the out-
board motor should be tilted up to protect the
propeller and lower case from damage by
collision with obstructions, and also to re-
duce salt corrosion.
EWM01544
WARNING
Make sure that all people are clear of the
outboard motor when tilting the outboard
motor up and down. Body parts can be
crushed between the outboard motor and
the clamp bracket when the outboard mo-
tor is trimmed or tilted.
ECM00993
NOTICE
 Before tilting the outboard motor, follow
the procedure under "Stopping engine"
in this chapter. Never tilt the outboard
motor while the engine is running. Se-
vere damage from overheating can re-
sult.
69
 To prevent the cooling water passages
from becoming frozen when the ambi-
ent temperature is 5°C (41°F) or below,
tilt the outboard motor up after it has
been stopped 30 seconds or more.
EMU3550B
Procedure for tilting up (power trim
and tilt models)
1. Place the control lever in neutral.
2. Press the power trim and tilt switch "
(up) until the outboard motor has tilted
up completely.
UP
N
ZMU05829
ZMU05837
"