Turning The Welding Element Off And Stowing It; Service And Maintenance; Service And Repair Contact; Accessories/Parts For The Product - Hürner HSE Manuel Utilisateur

to it: preparation and facing of the component butts, bead
build-up and heating at the welding element, jointing with no
(or inside-tolerance) misalignment and sufficiently long cooling
stage. (The nominal values to observe for these parameters are
defined by the welding standard used or national or local techni-
cal rules.)
4.2

Turning the Welding Element off and Stowing it

When you are done welding, unplug the power cord from the mains
outlet and wait for the welding element to cool down completely
before stowing it away in its transport case.
3

Service and Maintenance

The maintenance of the product is limited to the removal of plastic
residues, if any, after welding. Clean them off by hand or using a blunt
object if they have to be "scratched off." When removing any such
residues, be sure not to damage the coating of the welding element
in any way.
It is generally easier to clean off any residues when the weld-
ing element has not cooled down completely yet. In case of
removal by hand, in that situation it is absolutely indispens-
Caution able to wear protective gloves to avoid any burn wounds.
6

Service and Repair Contact

HÜRNER Schweisstechnik
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Web: www.huerner.de
We reserve the right to change technical specs of the product
without prior notice.
Info
7

Accessories/Parts for the Product

Tabletop Stand
Transport Case
(for all model versions except HSE 250)
8
EN
Tel.: +49 (0)6401 9127 0
Fax: +49 (0)6401 9127 39
E-mail: info@huerner.de
200 - 240 - 003
200 - 216 - 008
HÜRNER HSE User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Version July 2017