Technical Specifications; Operation; Performing A Welded Joint - Hürner HSE Manuel Utilisateur

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
3.2

Technical Specifications

Power supply
Compatible materials
Actual temperature range
(welding elements without temperature control/se-
lector preset to temperature for PE)
Max. diameter of components
Rated power
Dimensions
Weight
The model number is descriptive of the diameter of the
welding element rather than of the maximum component
diameter that can be welded using that model. The HSE
120, 30° model version has an element angulated by 30 deg.
Info
with respect to the handle. With all other model versions,
the heating surface is in a straight line from the handle.
All model versions are available with and without tempera-
ture control and the selector allowing to set the desired
temperature with those that have temperature control.
Info
In the standard delivery, the tabletop stand is not included,
but can be added upon request. Please contact the manufac-
turer or seller of the product.
Info
4

Operation

If a handheld welding element without temperature control
and temperature selector is used and a material other than
that for which it is (pre-) set is to be welded, the tempera-
Important
ture has to be changed first. The temperature set ex works is
that for polyethylene (PE). Only an authorized seller/service
partner is allowed to perform such a temperature setpoint
change.
5.1

Performing a Welded Joint

1. Install the welding element on the tabletop stand — supplied
optionally or not, depending on the product version that was
ordered — or another support not raising any safety concerns
and turn it on by plugging the power cord into a mains supply
outlet.
If the welding element were installed on an inappropriate
stand or simply laid down somewhere while it is hot, this
would expose the user and the assets around it to serious
fire hazards. Compliance with all safety messages quoted in
Caution
Sect. 2 is mandatory.
2. If the welding element used has a temperature control and selec-
tor, set the selector to the temperature required by the material
to be welded. The welding element — whether with or without
temperature selector — has reached the nominal temperature and
is ready for welding as soon as the green status lamp is on.
3. Using the handheld welding element, perform the butt-welding
operation observing all technical nominal values applicable
Version July 2017
Model Version 120, 30°
110 mm
0.5 kW
340 x 100
x 110 mm
1.5 kg
HÜRNER HSE User's Manual
120 160
2 3 0 V A C o r 1 1 0 V A C , 5 0 / 6 0 H z
P E , P P , P B ,
1 8 0 ° C - 3 0 0 ° C ( 3 5 6 ° F - 5 7 2 ° F )
110 mm 150 mm
0.5 kW 0.9 kW
340 x 100 420 x 60
x 110 mm x 190 mm
1.3 kg 2.4 kg
190 250
P V C , P V D F
180 mm 240 mm
0.9 kW 1.4 kW
420 x 60 510 x 60
x 190 mm x 280 mm
2.4 kg 3.3 kg
7
EN