Intended Use; Power Supply; Product Description; General View - Hürner HSE Manuel Utilisateur

The work zone has to be clean and has to have proper light-
ing. It is dangerous to operate while it is raining, in a humid
environment, or close to flammable liquids. In regard of this,
Caution
acceptable work conditions have to be ensured (tent, heat-
ing, etc.).
When the welding element is in operation and hot, it has to
be set down only on the optional tabletop stand or another
support that must not raise any concerns in terms of work
Caution
safety and safety of and for the environment.
2.2

Intended Use

The product is intended exclusively for jointing plastic pipes and fit-
tings according to the butt-welding process with heating element.
The notion of intended use also includes:
• Compliance with the instructions in the User's Manual
• Proper maintenance and cleaning of the product
All uses other than those mentioned above are not allowed
and will cancel any and all liability or warranty by the manu-
facturer. Unintended use, including failure to use the tabletop
Important
stand or another suitable support, may cause considerable
hazards and material damage.
2.3

Power Supply

Power shall be supplied to the product exclusively through the supplied
power cord and, if on-site extension cords are used, through extensions
that are appropriate and identified/approved as such.
3

Product Description

3.1

General View

6
EN
HÜRNER HSE User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Handle
Status Lamps
Heating Surface
Temperature
Selector
(only model versions with
temperature control)
Version July 2017