Cleaning The Dust Passage (See Figure B) - Wurth Master HBS 533 Traduction De La Notice Originale

OBJ_BUCH-1105-001.book Page 13 Tuesday, December 8, 2009 11:03 AM
Particularly when sanding coats of varnish, sand in
the direction of the grain as the varnish could melt
and smear the surface of the workpiece and the
sanding belt. Therefore, work with dust extraction.
A sanding belt used for sanding metal should not be
used for other materials.
Use only original Würth sanding accessories.
Store sanding belts only hanging; avoid creasing, as
this makes the belts unusable.
The sanding frame (accessory) allows for uniform
and controllable removal capacity when surface
grinding larger wooden surfaces.
Maintenance and Cleaning
❏ Before any work on the machine itself,
pull the mains plug.
❏ For safe and proper working, always keep
the machine and ventilation slots clean.
Remove adherent sanding dust with a brush.
Cleaning the Dust Passage
(see figure B)
From time to time, remove the protection cover 11
and clean the dust passage 12 so that the suction
capacity remains at an optimum level.
Changing the Graphit Plate
(Accessory) (see figure C)
The graphite plate 13 (accessory) is screwed onto
the guide plate 14 and enables an optimum sanding
pattern.
The graphite plate 13 is subject to wear, depending
on the intensity of usage. To change the graphite
plate 13, remove the sanding belt 2. Unscrew the
graphite plate 13 and replace it. After mounting the
sanding belt, adjust the belt run as described in sec-
tion "Changing the Sanding Belt" on page 12.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair
should be carried out by a Würth master-Service.
In all correspondence and spare parts orders, please
always include the article number given on the type
plate of the machine.
The current spare parts list for this power tool can be
viewed in the Internet under
"http://www.wuerth.com/partsmanager"
or be requested from your next Würth branch office.
8.12.09
Guarantee
For this Würth power tool, we provide a guarantee
in accordance with the legal/country-specific regula-
tions from the date of purchase (verified by invoice
or delivery document). Damage that has occurred
will be corrected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the guarantee.
Claims can only be accepted if the power tool is sent
undisassembled to a Würth branch office, your
Würth sales representative or a customer service
agent for Würth power tools.
Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into house-
hold waste!
According to the European Guideline
2002/96/EC for Waste Electrical and
Electronic Equipment and its implementa-
tion into national right, power tools that are no
longer usable must be collected separately and dis-
posed of in an environmentally correct manner.
Subject to change without notice.
English–13