Intex Prism Frame 157-1/2x78-3/4x48 Manuel D'utilisation page 7

POOL SETUP ( continued )
You may have purchased this pool with the Intex Krystal Clear™ filter pump. The pump has its
own separate set of installation instructions. First assemble your pool unit and then set up the
filter pump.
Estimated assembly time 60~90 minutes. (Note the assembly time is only approximate and
individual assembly experience may vary.)
1. • Find a flat, level location that is free and clear of stones, branches or other sharp objects that may
puncture the pool liner or cause injury.
• Open the carton containing the liner, joints, legs, etc., very carefully as this carton can be used to
store the pool during the winter months or when not in use.
• Spread a ground cloth (not included) over the cleared
area. Remove the liner (13) from carton and spread it
out over the ground cloth with the drain valve towards
the draining area. Place the drain valve away from the
house. Open it up to warm it in the sun. This warming
will make installation easier. Make sure the liner is
centered atop the ground cloth. Be sure to face the
end with the 2 hose connectors towards the electrical
power source.
IMPORTANT: Do not drag the liner across the
ground as this can cause liner damage and pool
leakage (see drawing 1).
• During the set-up of this pool liner, point the hose connections or openings in the direction of the
electric power source. The outer edge of the assembled pool is to be within reach of the electrical
connection for the optional filter pump.
2.
Remove all the parts from the carton(s) and place
them on the ground in the location where they are to
be assembled. Check the parts listing and be sure all
the pieces to be assembled are accounted for (see
drawing 2).
IMPORTANT: Do not start assembly if any pieces
are missing. For replacement pieces call the
Consumer Service telephone number in your area.
After all pieces are accounted for move the pieces
away from the liner for of installation.
NOTE: Sprinkle some talcum powder over the
horizontal beams before sliding them into the pool liner sleeve. This will make removal of the
beams from the liner easier during the disassembly of the pool.
3. • Be sure the liner is opened and spread out to its
fullest extent on top of the ground cloth. Starting
with one side, slide the "A" beams first into the
sleeve openings located in each corner. Continue
with "B" beam snapping into the "A" beam, and
another "A" beam snapping into the "B" beam (see
drawing 3.1).
Keep the metal beam holes aligned with the white
liner sleeve holes. Continue inserting all "A-B-A"
beams into the sleeve openings.
SAVE THESE INSTRUCTIONS
(82) PRISM FRAME™ OVAL PREMIUM POOL ENGLISH 7.5" X 10.3" PANTONE 295U 08/04/2020
5 - 6'
(1.5 - 2.0 m)
5 - 6' (1.5 - 2.0 m)
LINER
ELECTRICAL SOURCE
(A) (B) (A)
(C)
(C)
(D)
(D)
(C)
(C)
(A) (B) (A)
CORNER JOINT
CORNER JOINT
(A) (B)
(C)
(C)
LINER
(D)
(D)
(C)
(C)
(B) (A)
CORNER JOINT CORNER JOINT
(B)
(A)
English
82A
1
5 - 6'
(1.5 - 2.0 m)
2
3.1
(A)
Page 7