Intex Prism Frame 157-1/2x78-3/4x48 Manuel D'utilisation page 9

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
POOL SETUP ( continued )
7.
Pull the bottoms of the side supports out away from the
liner to make the straps taut. Repeat for all locations
(see drawing 7).
8.
If the ground is not concrete (asphalt, lawn or earth) you
must place a piece of pressure-treated wood, size
15" x 15" x 1.2", under each leg and set flush with the
ground. The U-shaped side supports must be placed in
the center of the pressure-treated wood and with the wood
grain perpendicular to the support leg (see drawing 8).
NOTE: Make sure each support pad is recessed and set
flush with the ground and not just placed on the ground.
Do not use support pads or slabs with slippery, smooth
surfaces as the U-shaped side support will slide outward
causing damage to the pool and void the warranty.
9.
Be sure the pool is set up, starting with one shorter side, insert a pin (16) through the seal (17) and
connect the corner joint (7) with the horizontal beam first, continue with "C" beam (5). The center
"D" beam (6) is designed to be moveable over the corner joints (7), do not insert any pins into the
pre-drilled holes between the center "D" beam (6) and the corner joints (7). Repeat this procedure on
the other short side of the pool.
Shake the pool to be sure that all the joints, legs and beams fit into each other. Ensure that all pins are
in position by pushing them downwards through the holes (see drawing 9).
IMPORTANT: The center "D" beam is designed to be moveable over the corner joints and not
fixed to the corner joints. This allows the pool side walls to move inward or outward when the
pool is in use.
10. Assemble the ladder. The ladder has separate assembly instructions in the ladder box.
11. Place the assembled ladder over one of the sides with one of the liner installation team members
entering the pool to smooth out all bottom liner wrinkles. While inside the pool this team member
should check the 2 drain valves (in corners) to be sure the inside drain plug is inserted into the valve.
This team member should push inside corner in an outward direction.
SAVE THESE INSTRUCTIONS
(82) PRISM FRAME™ OVAL PREMIUM POOL ENGLISH 7.5" X 10.3" PANTONE 295U 08/04/2020
6
7
5
English
11
Level
16
17
X
Page 9
82A
7
8
9

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Prism frame 157-1/2x78-3/4x39-3/8

Table des Matières