Basic Functions; Using The Radio - THOMSON RCD203U Mode D'emploi

BASIC FUNCTIONS

Note: Before using the appliance for the first time, remove
the cardboard protecting the lens located inside the CD
compartment (1). To open the CD compartment, use the
recess (15) to lift the cover up.
Switching the appliance off
Set the ON/OFF button (33) to OFF.
o
Then unplug the electrical cable.
Power off alarm
When the unit idle on CD or USB mode over 10 min. Then the
o
unit will switch to the Power Off Alarm mode automatically. At
Power Off Alarm mode, the unit will alert you to switch off the
unit by 10 sec. "Beep" sound and periodically by every 10 min.
for saving energy.
Setting the volume
To increase or decrease the volume, turn the VOLUME button
o
(2) to the right or the left or VOL-/VOL+ on the remote control.
EN 22
PORTABLE CD RADIO
RCD203U / RCD204U / RCD205U

USING THE RADIO

Set the function selector (3) to RADIO. The LCD screen (11)
o
lights up.
Set the band selector (16) to the type of frequency: FM ST.
o
(FM Stereo), FM (FM Mono) or MW.
Select the required radio station by turning the radio
o
frequency selector, TUNING (14).
Adjust the volume with the volume set button (2).
o
Unfold the telescopic aerial (20) when listening to FM/FM ST
o
stations.
The FM Stereo signal is weaker than the FM (mono) signal.
If reception of the FM ST. station is weak or crackles, try to
improve reception by adjusting the FM telescopic aerial or
switch to FM (mono) mode.
When FM ST. mode is selected, the FM ST. indicator (8) lights
up.
In MW mode, an aerial is integrated in the radio.
To improve radio reception, turn the radio to orient the
internal aerial and get the best possible reception. For MW
frequencies the stations are broadcast in mono only.
To switch the radio off, set the function selector (3) to OFF.
o