Samsung CM1929A Mode D'emploi page 152

4. Open the door and take the food out.
Close the door. The oven lamp will go off.
Whilst in a heating cycle, one press on (
time, the Power Check Indicator "ON" starts blinking and goes off when
the ( ) pad or ( ) button is pressed again.
You can restart it by pressing the (
pad will cancel the selected program. While NOT in a heating cycle, one
tap on ( ) pad cancels the selected program.
You can press +20sec pad one or more times in order to add the
cooking time by 20 seconds. But you can not exceed the maximum
time per power level allowed for power level selected.
When you first plug in the power cord, the oven beeps once and all the
indicators show for 5 sec in the display window.
When heating cycle is completed and you open the door, the oven lamp
automatically turns on and goes off 1 min later.
When you open the door whilst in a heating cycle, the oven stops
operating and the oven lamp automatically turns on for 1 min and goes
off 1 min later. If you leave the oven door open for more than 1 min, the
oven beeps once every minute and after 5 min the power source check
indicator 'ON' appears in the display window.
CM1529A_XEU_04030B_EN.indd 8
) pad stops the oven. At this
) button or a second press on ( )
8
Multi-stage cooking
1. Select the desired power level by pressing the
POWER LEVEL Selector pad or DEFROST pad.
Result : The selected power level will be
displayed in the display window.
2. Set the desired heating time by pressing the
NUMBER pads.
Result : The selected time is displayed in the
display window.
The maximum time according to each cooking power level can be referred
to in the title "Power Levels ans Time Variations" on page 7. The NUMBER
pads will not operate or respond when you press a cooking time exceeding
the maximum value. It is not possible to set a cooking time for longer than
the maximum time allowed on the chosen program. It is advisable to press
CANCEL and to enter a new power level and cooking time.
3. Repeat steps 1 and 2 for II or III stage memory programming.
4. Press the button.
Result : The oven lamp and cooling fan will be
turned
on. The oven will automatically start heating
according to pre-programed cooking time and
power level.(I stage J II stage J III stage).
The time on digital display will count down.
You can not set up the same POWER LEVEL or DEFROST.
It operates as setting up sequence.
2011-07-13 9:39:08