Ega Master 79632 Manuel D'instructions page 31

Visible grease nipples ar provided for regular lubrication of the gears with a grease gun. Note
the following for grease lubrication: Every 60 hours of operation check striking mechanism, friction
bearings and antifriction bearings; if necessary, grease them. Every 300 hours of operation grease the
gears and antifriction bearings anew. In the case of impact wrenches, use a grease gun to grease the
anvil guide before beginning daily work or every 6 to 8 hours. All inner parts must be lubricated before
storing for longer periods of time in order to prevent rusting.
It is recommended to check the vanes and bearings at regular intervals. Store pneumatic tools in
dry rooms only.
Lubricating oils to be used: Generally SAE 5 W to SAE 10
For gearless impact wrenches and small grinders, only SAE 5 W.
For damp compressed air, oils are to be used that take up water ( without losing the lubricating
effect) and that contain anticorrosive additives. At lower temperatures (especially for work outside) it
may be necessary to use an antifreeze lubricant (e.g. Kilfrost, BP Energol AX 10, Kompranol N 74).
For saw-chain lubrication on chain saws:
Machine oil with adhesive additive, viscosity c ST 49-55' (6.5-7.5 E)/ 50°C .
Greases ( free of resins and
acids)
Designation in accordance
with DIN 51502
Consistency class
(DIN 51818)
Saponification type
Dripping point
Worked penetration
Temperature range
Before starting: Check correct oiler setting!
Multi-purpose greases for
antifriction and friction
bearings
K L 2 k
2
Lithium
185 °C
265 to 295
-25°C to + 125°C
Special greases for high-
speed miter gears
G 000 h
00
Sodium
145°C
400 to 410
-25°C to + 100°C
31