Astralpool 27819 Manuel D'installation page 5

COLOUR Nº
1
2
3
4
5
6
7
8
9
10
11
12
Automatic sequence of colours: Selection of nine colour sequence programmes. Each programme is defined by the lighting time of
each colour and the transition time from one colour to another according to the following table:
For example, programme 5 indicates that each colour will stay for 30 seconds, out of which 22 seconds will be with one set colour
and the remaining 8 seconds are used in the transition to the following colour. Programme 8 indicates that the 60 seconds
corresponding to each colour are used in the transition to the following colour.
The colours used in the sequence can be selected from the 12 set colours. Proceed as follows to include them in the sequence:
Press the COLOUR key in the remote control. The colour number will be displayed preceded by the letter "C".
Press the ACTIVATION key and the letter "C" will alternately switch from an upper case letter to a lower case letter.
The colours activated with the upper case "C" will form part of the sequence.
NOTE: The spotlight is equipped with a heat protection device that, in the event of excess temperature, reduces the lighting level to
prevent overheating.
6.2.3 Receiver-modulator (code 27818)
Install the Receiver-Modulator where it is protected from corrosion, outside metal boxes
and at a distance from metal pipes or electrical cables that can block the Radio
Frequency signal from the remote control.
Operation of the Pushbuttons:
OFF:
To turn off the spotlight.
By keeping this button pressed (whether the spotlight is on or off), the receiver
enters the "Instruction" mode, that starts-up the remote control by pressing once
any key of the Control (See "Start-up").
ON / COLOUR:
If the spotlight is off or in the SEQUENCE mode, the spotlight is turned on in the SET COLOUR mode (the activated colour
will be the last set colour used).
If the spotlight is already in the SET COLOUR mode, press the button to change the colour within the 12 different options.
ON / SEQUENCE:
If the spotlight is off or in the SET COLOUR mode, the spotlight is switched on in the SEQUENCE mode. (The activated
programme will be the last one used) (programme or colour changes in the sequence should be performed from the remote
control).
% RED % BLUE
100 0
0 100
0 0
100 60
100 0
0 100
0 60
100 100
0 100
100 0
100 100
100 80
COLOUR TIMING
SEQUENCE
(SEC.)
1 4
2 8
3 15
4 15
5 30
6 30
7 60
8 60
9 120
% GREEN COLOUR
0 Red
0 Blue
100 Green
0 Magenta
60 Light yellow
60 Bluish cyan
100 Greenish cyan
0 Purple
100 Cyan
100 Yellow
80 Bluish white
100 Greenish white
BLENDING
TIMING (SEC.)
1
8
4
15
8
30
15
60
60