HP C2688A Mode D'emploi page 20

Message Value
IPX/SPX ON
DLC/LLC OFF
TCP/IP
ETALK
CFG IPX/SPX NO
YES
CFG TCP/IP NO
YES
5-4
Description
Selects whether or not a protocol is enabled
or disabled. Change it to OFF to disable a
protocol.
Selects whether you want to access the
IPX/SPX menu and set the IPX/SPX protocol
parameters.
In the IPX/SPX menu, you can specify the
Frame Type parameter used on your
network.
• The default is AUTO, which automatically
sets and limits the Frame type to the one
detected.
• For Ethernet cards, frame type selections
include EN_8023, EN_II, EN_8022,
EN_SNAP.
• For Token Ring cards, frame type
selections include TR_8022, TR_SNAP.
In the IPX/SPX menu for Token Ring cards,
you can also specify NetWare Source
Routing parameters, which include SRC
RT=AUTO (default), OFF, SINGLE R or ALL
RT.
Selects whether you want to access the
TCP/IP menu and set the TCP/IP protocol
parameters.
In the TCP/IP menu, you can specify
BOOTP=YES for TCP/IP parameters to be
automatically configured by a BootP or
DHCP server when the printer is turned on.
If you specify BOOTP=NO, you can
manually set the following TCP/IP
parameters from the control panel:
Each byte of the IP address (IP)
• Subnet Mask (SM)
• Syslog Server (LG)
• Default Gateway (GW)
• Idle Timeout period (default is 90 seconds,
0 disables the timeout)
When setting IP numbers, press the Value
button to increase the number by 1. Hold
down the Value button to increase the
number by 10. Press the Resume button to
make your selection.