WaterLink SpinTouch 3580 Traduction Des Instructions Originales page 7

Find Quality Products Online at:
¬ Gently wipe smudges from the screen with the Cloth Wipe (3580-WIPE).
¬ Do not touch the screen with a sharp object.
¬ Do not place objects on the screen that will scratch or damage it.
¬ Avoid touching the screen with wet fingers.
TESTING
Sanitizer
Salt
Disk Series
203
16-Apr-20
12:14 AM
1. Press and hold until the meter turns on.
2. Tap . Select a sanitizer type. Tap
3. Tap . Select a disk series (found on disk packaging). Tap
NOTE: Disk Series are limited by Sanitizer selection.
4. Remove a disk from the packaging.
5. Use the syringe (1189) to fill the disk with the pool or spa water sample.
6. Insert the disk. Cover the disk with the Universal Disk Cover (1719). Close the lid.
7. Tap to start test. Tap
disk.
8. The results will be displayed.
9. Choose an option.
¬ Tap to add a tag.
¬ Tap the highlighted
not enabled.
¬ Tap the hightlighted
Printer.
¬ Tap the highlighted
¬ Tap to return to the Test Screen.
10. Press and hold for 2 seconds to turn the meter off.
NOTE: For water samples over 100 °F (38 °C) subtract 0.3 from pH result or, for the most accurate
result, wait until water sample is below 90 °F (32 °C) to test.
Remove salt residue daily. Salt will damage the meter and cause inaccurate results. See cleaning page
20.
GlobalTestSupply
www.
Tap to
Start Test
to confirm.
to cancel the test. If the test is cancelled discard the
to save the test results to the test log if Auto Save is
to send the results to the enabled Mobile Bluetooth
to send the results to a Bluetooth enabled device.
8
.com
to confirm.
sales@GlobalTestSupply.com