Lanaform WBPM-110 Manuel D'instructions page 8

EN
FR NL DE
3 Connecting The Cuff To The Monitor.
The cuff is attached to the monitor when it is
packaged. Should the cuff become unattached,
align the two plugs and four brackets of the cuff
with the plug sockets and bracket sockets of the
monitor and press the cuff to the monitor until
the plugs and brackets are securely attached.
4 Applying The Cuff
a. Place the cuff around a bare
wrist 1-2cm above the wrist joint
on the palm side of the wrist.
b. While seated, place the arm with the
cuffed wrist in front of your body on a desk or
table with the palm up. If the cuff is correctly
placed, you can read the LCD display.
c. The cuff must be neither too
tight nor too loose.
infos Note:
a. Please refer to the cuff circumference
range in "SPECIFICATIONS" to make sure
that the appropriate cuff is used.
b. Measuring on left arm each time.
c. Do not move your arm, body, or
the monitor and do not move the
rubber tube during measurement.
d. Stay quiet, calm for 5 minutes before
blood pressure measurement.
e. Please keep the cuff clean. Clean the
cuff by wet soft cloth and mild detergent
if the cuff becomes dirty. Do not remove
the cuff from the monitor.Clean the cuff
after the usage of every 200 times is
recommended.Do not place the cuff around
8
/ 64 WBPM-110
your arm if the arm has any inflammation,
acute diseases, infections skin wounds.
5 Body Posture During Measurement
Sitting Comfortably Measurement
a) Be seated with your feet flat on the
floor, and don't cross your legs.
b) Place palm upside in front of you on a
flat surface such as a desk or table, with
your elbow resting on a chair or table
c) The middle of the cuff should be at the
level of the right atrium of the heart.
6 Taking Your Blood Pressure Reading
a. After applying the cuff and your body is
in a comfortable position, press the "START"
button. All display characters are shown for
self-test. You can check the LCD display accord-
ing to the picture. Please contact the service
center if segment is missing. See picture 6-1.
b. Then the current memory bank is blink. See
picture 6-2. Press "MEM" button to change