Lanaform WBPM-110 Manuel D'instructions page 10

EN
FR NL DE
8. Deleting Measurements From The Memory
When any result is displaying (exclude average value
displaying), keeping on pressing button "MEM" for
three seconds, all results in the current bank will be
deleted. See picture 8. Press the button "START", the
monitor will be turned off.
Classification of blood pressure for adults
Range of blood
pressure values
Level 3:
acute hypertension
Level 2:
intermediate
hypertension
Level 1:
mild hypertension
Normal high
Normal
Optimum
10.Technical Alarm Description
The monitor will show 'HI' or 'Lo' as technical alarm
on LCD with no delay if the determined blood pres-
sure (systolic or diastolic) is outside the rated range
specified in part SPECIFICACIONS. In this case, you
should consult a physician or check if your operation
violated the instructions.
10
/ 64 WBPM-110
9.
The following guidelines for assessing high blood
pressure (without regard to age or gender) have been
established by the World Health Organization (WHO).
Please note that other factors (e.g. diabetes, obesity,
smoking, etc.) need to be taken into consideration.
Consult with your physician for accurate assess-
ment, and never change your treatment by yourself.
Systolic (in mmHg) Diastolic (in mmHg)
≥ 180 ≥ 110
160 – 179 100 - 109
140-159 90 - 99
130 - 139 85 - 89
120 - 129 80 - 84
<120 <80
The technical alarm condition (outside the rated
range) is preset in the factory and cannot be adjusted
or inactivated. This alarm condition is assigned as
low priority according to IEC 60601-1-8.
The technical alarm is non-latching and need no
reset. The signal displayed on LCD will disappear
automatically after about 8 seconds.
Assessing High Blood Pressure For Adults
Value displayed
3
2
1
N
N
N