Lanaform WBPM-110 Manuel D'instructions page 12

EN
FR NL DE
Troubleshooting (2-2)
PROBLEM
LCD shows « ER 5»
LCD shows « ER 6 »
LCD shows « ER 7 »
LCD shows « ER 8 »
LCD shows « ER A »
No repsonse when you press
button or load battery
9. MAINTENANCE
1 report_p Do not drop this monitor or
subject it to strong impact.
2 report_p Avoid high temperature and solarization.
Do not immerse the monitor in water as
this will result in damage to the monitor.
3 If this monitor is stored near
freezing, allow it to acclimate to
room temperature before use.
4 report_p The monitor requires 6 hours to
warm from the minimum storage
temperature between uses until the
monitor is ready for its INTENDED USE
when the ambient temperature is 20 °C.
5 The monitor requires 6 hours to cool
from the maximum storage temperature
between uses until the the monitor
is ready for its INTENDED USE when
the ambient temperature is 20 °C.
6 report_p Do not attempt to disas-
semble this monitor.
12
/ 64 WBPM-110
POSSIBLE CAUSE
Cuff pressure above 300mmHg
More than 160 seconds with cuff
pressure above 15 mmHg
Inner Memory error
Device parameter checking error
Pressure sensor parameter error
Incorrect operation or strong
electromagnetic interference
7 If you do not use the monitor for a long
time, please remove the batteries.
8 It is recommended the performance
should be checked every 2 years or after
repair. Please contact the service center.
9 Clean the monitor with a dry, soft cloth
or a soft cloth squeezed well after
moistened with water, diluted disinfectant
alcohol, or diluted detergent.
10 No component can be maintained by
user in the monitor. The circuit diagrams,
component part lists, descriptions,
calibration instructions, or other information
which will assist the user's appropriately
qualified technical personnel to repair
those parts of equipment which are
designated repairably can be supplied.
11 The monitor can maintain the safety and
performance characteristics for a minimum
of 10,000 measurements or three years,
and the cuff integrity is maintained after
1,000 open–close cycles of the closure.
SOLUTION
Measure again after five minutes.
If the monitor is still abnormal,
please contact the local distribu-
tor or the factory
Take out batteries for five
minutes, and then reinstall all
batteries.