Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. OPERATION
You can control the hood by the switch on the hood.
① switch on / off
② decrease speed levels
③ increase speed levels
④ illumination
⑤ and ⑥ LED indication speed level
3.1 Extraction
Switch on – switch off
To switch the motor on push button ①. The hood will
always resume the level it was previously switched off
in.
Switch off with 10 minute delay:
Press button ① once. The first green LED blinks, the
other LED's remain lit up according to the level in use.
After 10 minutes motor and illumination switch off
automatically.
Switch off without delay:
Push button ① twice.
Auto-Stop
To avoid that the hood will function during a too long
period, it will switch off automatically after 3 hours (when
no changes to the controls have been made). Only the
motor will turn off automatically. The lighting will stay on.
Levels of intensity
To decrease speed levels push button ②. To increase
speed levels push button ③. Three green LED's ⑤
indicate level 1 to 3, one red LED ⑥ indicates the level
'POWER'.
POWER' is only used in case of excessive formation of
smoke, fumes or odours. Taking into account the large
volume of air which is extracted from the room at this
level, it's use should be limited.
'POWER' automatically reverts to level 3 after 6 minutes.
A self-rectifying thermal contact makes sure that
the motor is switched off when overheated. The motor
will switch on again after is has cooled down. The cause
of the overheating needs to be determined. This
may be, for example, that the contents of the pan have
caught fire, the motor fan is blocked or an object is
(partly) closing off the exhaust opening.
3.2 Illumination
To activate the lights press button ④. The lights will
switch on at full power. Lighting can be activated
independently from the motor.
3.3 Remote control (only for the models 895, 897,
899)
1) illumination
2) increase speed levels
3) decrease speed levels
4) switch on / off
5) Novy-button - Not applicable
The remote control for hood is preinstalled and ready
for use.
Programming the remote control
If the set frequency disrupts other transmitters,
another code can be selected using the remote
control. There are 10 different codes.
Determine the code used
Simultaneously press
mote control flashes as many times as the selected
code (there are 10 code options in total).
Change the code:
• Simultaneously press
• The lamp on the remote control flashes as many
times as the selected code. Repeat this step until you
have reached the required code (there are 10 code
options in total).
• Simultaneously press on the cookerhood
til the second green Speed indicator lamp is blinking.
• Press the key
on the remote control within 10 sec-
onds to confirm the settings. The cooker hood and
the remote control are now in line with each other.
Change the batteries:
• For changing the batteries unscrew the plastic cover,
remove the old batteries and insert the new ones.
Pay attention to the polarity marking given in the bat-
tery compartment
and
.The lamp on the re-
and
.
+
EN 18
un-
Publicité
Table des Matières
