Emist Tru Electrostatic EX-7000 Instructions De Montage page 9

EMIST EX-7000 TRUELECTROSTATIC
SPRAYER COMPONENTS
AFTER UNPACKING, INSPECT COMPONENTS
FOR ANY DAMAGE OR MISSING HARDWARE PIECES, ETC.
� 3.1 L Interchangeable Liquid Tank
� (2) 14.4V Rechargeable Batteries
1.
INSTALL BATTERY (PROCEDURE SAME
FOR BOTH BATTERY PORTS):
Charge the battery first:
a. Plug charger cord into wall outlet.
1. Install battery into charger.
2. Reference power indicator (3 bars = full charge).
b. With the power pack battery ports located toward the bottom of
each side:
1. Install the battery into one port. With the battery release
button facing up, gently push the battery into the port and the
battery will click into place.
2. Depress the trigger on the applicator to verify power is on.
Red indicator light on the back of the handle will turn red and
the system will engage.
2.
LIQUID TANK REMOVAL:
a. Locate the tank latch toward the top center of the
back panel of the power pack. Gently pull and hold the
latch away from the unit, this will release the tank.
b. With the latch pulled back, firmly grip the tank's
handle and pull straight up.
c. Lift the liquid tank out of the power pack.
3.
LIQUID TANK INSTALLATION:
a. For initial set up/test, fill the liquid tank 1/4 full with water.
b. Gently slide the tank back into the power pack.
c. When the tank is fully insterted, it will lock/click into place.
©2021 EMist® is a registered trademark of SanoTech 360, LLC. All rights reserved.
INSPECTION
� Power Pack with Applicator
� Battery Charger
� Backpack Harness
EMI-018-21 - EX-7000 - 041921
EN
GENERAL
PRECAUTIONS &
SAFETY WARNINGS
INITIAL INITIAL
INSPECTION & INSPECTION &
SET UP SET UP
ASSEMBLY &
OPERATION
INSTRUCTIONS
SPRAY
APPLICATION
MAINTENANCE
& CLEANING
TROUBLESHOOTING,
SUPPORT
& REPAIR
9