Emist Tru Electrostatic EX-7000 Instructions De Montage page 10

EN
GENERAL
PRECAUTIONS &
SAFETY WARNINGS
INITIAL INITIAL
INSPECTION & INSPECTION &
SET UP SET UP
ASSEMBLY &
OPERATION
INSTRUCTIONS
SPRAY
APPLICATION
MAINTENANCE
& CLEANING
TROUBLESHOOTING,
SUPPORT
& REPAIR
10
4.
POWER PACK AND APPLICATION FUNCTION
CHECK:
a. With the tank and battery installed, depress the trigger
switch located on the front of the applicator handle.
b. The clear LED on the back of the applicator handle will
light up RED. This indicates power on and the high
voltage power supply is engaged and charging the liquid
droplets.
c. Once the trigger switch is released, the liquid spray will
stop, and the fan will turn off. This indicates the system
is off.
HOW TO ATTACH HARNESS TO POWER PACK
1. Position the hydroelectric cord toward the front of the
system out of the way. Open the flap on the harness. Feed
it under the vertical nylon strap attached to the power
pack of the EX-7000 system. Fold the flap back toward
the harness and match the two sides of hook and loop
fastening strips, securing the harness to the power pack.
2. Repeat step 1 for the second flap on the harness.
3. Connect the two ends of the side squeeze buckle
connectors between the harness and the power pack.
©2021 EMist® is a registered trademark of SanoTech 360, LLC. All rights reserved.
EMI-018-21 - EX-7000 - 041921
1
3
2