Troubleshooting, Support & Repair - Emist Tru Electrostatic EX-7000 Instructions De Montage

EN
GENERAL
PRECAUTIONS &
SAFETY WARNINGS
INITIAL
INSPECTION &
SET UP
ASSEMBLY &
OPERATION
INSTRUCTIONS
SPRAY
APPLICATION
MAINTENANCE
& CLEANING
TROUBLESHOOTING, TROUBLESHOOTING,
SUPPORT SUPPORT
& REPAIR & REPAIR
18
TROUBLESHOOTING, SUPPORT, & REPAIR
INDICATIONS & REMEDIES
PLEASE SEE BELOW FOR EASY INSTRUCTIONS FOR ADDRESSING
ISSUES THAT MAY ARISE WHILE USING THE EX-7000™
Issue Reason
Battery not charged
Battery not installed
correctly
No power
to the
system
Battery connection
not working
Red LED not
illuminating when
trigger switch is
engaged
Tank is empty
Battery not charged
Tank is not installed
correctly
in the power pack
No mist/
inadequate
mist
Leaking at the nozzle
Nozzle clogged
Pump not engaged
System Main electrical
turns on components have
and off been exposed to
automatically
©2021 EMist® is a registered trademark of SanoTech 360, LLC. All rights reserved.
EMI-018-21 - EX-7000 - 041921
Fully charge the battery (3 bars
Install battery with connector side
of battery entering the power
pack; keep battery release button
facing upwards as it slides into
Verify battery connector issue by
using the opposing battery port
Verify a fully charged battery,
installation of battery is correct,
no obstruction when inserting the
Fill tank with appropriate liquid
Fully charge the battery (3 bars
Verify the tank is locked into place
as instructed for insertion
Verify the nozzle tip is hand
Remove nozzle tip from sprayer,
rinse with water. Reinstall, hand
Verify all the above troubleshooting
Verify if liquid is noted coming out
of the bottom of the system
liquid
Troubleshooting
= full)
the port
with charged battery
battery
= full)
tightened in place
tightened
steps for results