Spray Application; Preparing The Spray Area - Emist Tru Electrostatic EX-7000 Instructions De Montage

EN
GENERAL
PRECAUTIONS &
SAFETY WARNINGS
INITIAL
INSPECTION &
SET UP
ASSEMBLY &
OPERATION
INSTRUCTIONS
SPRAY SPRAY
APPLICATION APPLICATION
MAINTENANCE
& CLEANING
TROUBLESHOOTING,
SUPPORT
& REPAIR
14
A. PREPARING THE SPRAY AREA:
1. Make sure food and drinks are removed, or covered before
application.
2. Spotless, clean interiors require no prep work prior to application.
3. Loose debris must be swept from floors and other surfaces prior to
application.
4. Inspect the area for mechanical barriers such as: magazines
on table tops, chairs touching each other, a table or a wall.
The intended target surface area for application will need to be
accessible.
5. Please cover and remove valuables. Electronics, furniture, paper
or other common necessities do not need to be removed from the
area.
6. Once the area has been cleaned, application can begin.
7. This system is NOT a mechanical cleaner.
B. SPRAY APPLICATION PROCESS:
1. EMist recommends the use of disinfecting products on EPA's
Disinfection List N that are approved for electrostatic application.
2. Begin at the farthest point from the doorway, work back toward the
doorway so you can step out when application is complete.
3. Aim applicator wand 24"-36" (optimal distance) from the surface
target area, begin with a smooth figure "S" movement aiming below,
at, and above the surface target area while walking at an average
pace (continuously moving).
4. Make sure you are working in a methodical "S" pattern and let your
passes overlap when moving to the next surface target area.
5. Allow treated area to sit for contact time as recommended by the
chemical manufacturer's label before re-entry into the area.
TIP: IF THE APPLICATOR BECOMES WET OR BEGINS TO DRIP,
YOU ARE MOVING TOO SLOWLY OVER THE SURFACE TARGET
AREA AND NEED TO SPEED UP THE APPLICATION PROCESS.
DO NOT OVER-SATURATE THE SURFACE. IF YOU SEE RUNS
OR PUDDLES YOU ARE APPLYING TOO MUCH CHEMICAL.
THE GOAL IS TO ACHIEVE EVEN COVERAGE OVER THE
TARGET SURFACE AREA.
©2021 EMist® is a registered trademark of SanoTech 360, LLC. All rights reserved.
EMI-018-21 - EX-7000 - 041921

SPRAY APPLICATION