Battery Removal - Emist Tru Electrostatic EX-7000 Instructions De Montage

MAINTENANCE & CLEANING

BATTERY REMOVAL

• Remove battery by depressing the battery release button.
• The battery will slide easily from the port once it is disengaged.
• Place batteries into charger to fully charge for next usage.
Each battery takes approximately 45 minutes to fully charge.
• Store batteries and chargers in a cool, dry place.
CAUTION: DO NOT STORE THE SYSTEM IN AN AREA
THAT MAY FREEZE (TO AVOID DAMAGE FROM LIQUID
REMAINING IN THE SYSTEM AND LINES). THIS WILL
VOID THE WARRANTY.
STORAGE
• Empty fluid or run until empty.
• Insert at least 1 inch (2.5cm) of clean water in the liquid
tank.
• Run the electrostatic sprayer for at least 1-2 minutes to
flush active chemicals from the system.
• Remove batteries and re-charge by placing on
the charger.
• Wipe down exterior with water or alcohol to remove dirt
and soil.
• Use the power indicator on the end of the battery to
determine the battery state of charge (3 bars = full
charge).
• Coil the hydroelectric cord up neatly and securely.
©2021 EMist® is a registered trademark of SanoTech 360, LLC. All rights reserved.
EMI-018-21 - EX-7000 - 041921
EN
GENERAL
PRECAUTIONS &
SAFETY WARNINGS
INITIAL
INSPECTION &
SET UP
ASSEMBLY &
OPERATION
INSTRUCTIONS
SPRAY
APPLICATION
MAINTENANCE MAINTENANCE
& CLEANING & CLEANING
TROUBLESHOOTING,
SUPPORT
& REPAIR
17