Maintenance & Cleaning - Emist Tru Electrostatic EX-7000 Instructions De Montage

EN
GENERAL
PRECAUTIONS &
SAFETY WARNINGS
INITIAL
INSPECTION &
SET UP
ASSEMBLY &
OPERATION
INSTRUCTIONS
SPRAY
APPLICATION
MAINTENANCE MAINTENANCE
& CLEANING & CLEANING
TROUBLESHOOTING,
SUPPORT
& REPAIR
16
MAINTENANCE & CLEANING
FLUSHING THE ELECTROSTATIC SPRAYER
IT IS IMPORTANT TO FLUSH THE APPLICATION SYSTEM AT
LEAST EVERY 24 HOURS WITH CLEAN WATER BETWEEN
EACH USE. DO NOT STORE CHEMICALS IN THE RESERVOIR
WHILE THE SYSTEM IS NOT IN USE FOR GREATER THAN A
24 HOUR PERIOD.
The system is designed to minimize maintenance
and cleaning.
• Clear the system at least once a day by spraying clean water
through the system for at least 1-2 minutes.
• Some chemicals are harsher or more volatile than others.
Because corrosion caused by chemicals is not covered under
Manufacturer's limited warranty, it is imperative that you properly
flush the system as directed herein. Note that the use of some
chemicals may require more frequent flushing of the system
based on the chemicals corrosive nature. Signs of failing to
properly flush the system include clogged nozzle, hardened or
calcified hoses or lines, deterioration of the plastics such as the
manifold, and/or clogged filters.
• Keep batteries charged.
• Inspect cord for cuts, tears or damage.
• Inspect applicator for debris or damage.
CHANGING CHEMICALS:
IT'S IMPORTANT TO FLUSH THE SYSTEM IN
BETWEEN USE OR WHEN SWITCHING CHEMISTRY
TO PREVENT RESIDUAL BUILD UP OR CORROSION AND
TO AVOID MIXING CHEMICALS.
• To flush the system, empty the liquid tank and fill with at least 1
inch (2.5cm) of clean water.
• Spray for at least 1-2 minutes to flush the previous fluid from the
system.
©2021 EMist® is a registered trademark of SanoTech 360, LLC. All rights reserved.
EMI-018-21 - EX-7000 - 041921