Campbell Hausfeld PW340200 Instructions D'utilisation page 12

ASSEMBLY INSTRUCTIONS (FIGURES 16 AND 17)
1. Locate and remove all loose parts from the carton.
2. Cut four corners of the carton from top to bottom and lay the
panels flat.
3. Slide the handle assembly (G) onto the frame (H) and secure
with saddle bolts and knobs.
to prevent pinching.
4. Remove the colored quick-connect nozzles (K)
from the plastic bag and insert them into correct
grommet on the nozzle holder (L). Nozzles are color
coded to match colored nozzles on label.
5. Connect wand (E) to gun (D). Tighten securely.
6. Attach high pressure hose (C) to gun (D). Tighten
se cure ly.
warranty.
OPERATING INSTRUCTIONS
Pressure Washer Terminology
PSI: Pounds per Square Inch. The unit of measure for water pressure. Also used for air pressure, hydraulic
pressure, etc.
GPM: Gallons per Minute. The unit of measure for the flow rate of water.
CU: Cleaning Units. GPM multiplied by PSI equals CU.
Bypass Mode: Allows water to re-circulate within the pump when the gun trigger is not pulled. This feature
allows the operator to release the trigger gun and reposition themselves without having to turn the engine
off in between cleaning actions.
rises too high, the thermal relief valve will open and release a spray of water from the pump to lower the internal
temperature. The valve will then close.
Thermal Relief Valve (Figure 18): When the temperature inside the pump rises too high, this
valve will open and release a gush of water in an effort to lower the temperature inside the
pump. The valve will then close.
Detergent Injection System: Mixes cleaners or cleaning solvents with the water to improve
cleaning effectiveness.
Water Supply: All pressure washers must have a source of water. The minimum requirements
for a water supply are 20 PSI and 5 Gallons Per Minute. If your water source is a well, the
garden hose length can only be 30 ft. (9 m) max.
Risk of personal injury. Avoid placing hands
between handle and frame when assembling
The engine is shipped without oil. Before starting engine, add the oil provided. Damage to the
engine will occur if the engine is run without oil, this damage will not be covered under
The high-pressure pump was filled with oil at the factory. Always check oil level before using
(refer to Maintenance for more information).
Do not allow the unit to run for more than two minutes without the gun trigger being pulled.
This could cause overheating and damage to the pump. When the temperature inside the pump
To reduce the possibility of contamination always protect against backflow when connected to
a potable water system.
10
G
H
Figure 16
E
D
Figure 17
K
L
D
C
P
Figure 18