Important - Campbell Hausfeld PW340200 Instructions D'utilisation

QUICK SETUP GUIDE
Install the Handle
Slide the handle assembly onto the frame and secure with saddle bolts and knobs.
Add/Check Oil
The engine is shipped without oil. Before starting engine, add the oil provided.
Check oil level prior to each use. Refer to Engine Owner's Manual for complete
procedure.
Add Gasoline
In a well ventilated outdoor area add fresh, high quality, unleaded gasoline with
a pump octane rating of 86 or higher. Do not overfill. Wipe up spilled fuel before
starting the engine. Refer to Engine Owner's Manual for complete procedure.
IMPORTANT: Ethanol Shield
eliminate and prevent ethanol related problems in power equipment. Follow the
instructions on the container and add to the gasoline.
QUICK START GUIDE
• Never run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust contains carbon monoxide, an
odorless and deadly gas.
• Risk of fluid injection and laceration. When using the high-pressure setting, DO NOT allow the high-pressure spray
to come in contact with unprotected skin, eyes or with any pets or animals. Serious injury will occur.
Connect Garden Hose to Pump
Thread the garden hose to the pump inlet.
Connect High Pressure Hose to Pump
Connect the high pressure hose to the pump outlet.
Connect High Pressure Hose to Spray Gun
Thread the other end of the high pressure hose to the spray gun.
To reduce the risk of injury, read the pressure washer instruction manual and the engine
instruction manual before operating pressure washer.
(sold separately) is a fuel stabilizer that helps
TM
8
Figure 2 - Install handle
Figure 3 - Add/check oil
Figure 4 - Add gasoline
Figure 5
Figure 6
Figure 7