The Door; Insulation Of Other Items; Installing The Outside Unit; Make Sure You Have Chosen The Best Place For Fitting The Outside Unit - WINEMASTER FONDIS SP 100 Mode D'emploi

2.3.5

THE DOOR

It is part of the continuity of insulation.
There are two possible solutions :
to insulate the existing door using the same type as insulation as was used for the cellar walls. Insert a seal
-
such a foam, between the door panel and the frame all around the edge.
Use a FONDIS isothermal door, lined with polyurethane foam. It includes a seal around its periphery, with
-
a magnetic closure..
2.3.6

INSULATION OF OTHER ITEMS

A fridge or another appliance producing heat must not be placed inside the cellar. For example, any hot water pipe
going through the cellar must also be insulated.
3

INSTALLING THE OUTSIDE UNIT

Before any intervention with interior of the unit, the electric cable must be disconnected.

Make sure you have chosen the best place for fitting the outside unit :

- Chose the best place in order that the length of the flexible connection will be shorter as possible.
- There should not be any obstacle in front of the ventilation grid and the back of the unit, to
facilitate air flow
- The wall structure should be strong enough to carry the unit weight and avoid deformations
rupture, or vibration during operation
3.1

DRILLING THE WALL

Drill one hole of diametre 70mm to allow the connection of the flexible refrigerant tube to the unit.
3.2

FLEXIBLE DISMOUNTING

3.2.1

THE COVER

2
1
8