Oase InScenio 230 Notice D'emploi page 8

- EN -
Installing the unit
• Set-up the unit horizontally and water-protected, at a dry location, at least 2 m from the edge of the pond (B, C).
How to proceed:
1. Remove the protection hood from the unit.
2. Fully insert the ground stake into the ground.
3. Slide the device onto the ground stake.
4. Check its stability.
Connecting the power supply
This is how to connect the power supply:
• Push the female connector of the power supply (4) onto the unit plug (5).
The connection is made on the unit rear (D).
Connect the units to the power supply distributor
• If necessary, remove the protection hood from the power supply distributor.
• Only connect one unit per socket.
• Make sure that your OASE unit may be connected to this socket. For this purpose, consult the instructions of use of
the unit you wish to connect.
• Connect the unit.
• Do not connect any InScenio controllers or portable multiple sockets to the unit.
• Always use the pull relief (E, 6) provided on the unit for the connection cables.
Switching off the unit
• The device is only de-energised when the plug of the mains supply cable is unplugged.
Maintenance and cleaning
W A R N I N G
Electrical current may cause death or severe injuries.
• Disconnect the power plug before carrying out any work on the unit.
Cleaning the device
Clean the unit with a soft, clean and dry cloth. Never use aggressive cleaning agents or chemical solutions. These can
attach the housing surface or impair the function.
Spare parts
The use of original parts from OASE ensures continued
safe and reliable operation of the unit.
Please visit our website for spare parts drawings and spare
parts.
Disposal
N O T E
Do not dispose of this unit with domestic waste.
• Render the unit unusable beforehand by cutting the cables and dispose of the unit via the return system
provided for this purpose.
8
www.oase-livingwater.com/spareparts