Electrolux ST23012 Notice D'utilisation page 33

9. Fit the doors into the pins and install the doors.
Install the hinge.
2
1
10. On the opposite site, install the hole covers
provided within the accessory bag.
16) If foreseen
11. Tighten the hinge. Make sure that the doors
are aligned.
12. Remove and install the handle
posite side.
13. Reposition, level the appliance, wait for at least
four hours and then connect it to the power
socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
3
If the ambient temperature is cold (i.e. in Winter),
the gasket may not fit perfectly to the cabinet. In
that case, wait for the natural fitting of the gasket.
In case you do not want to carry out the above
mentioned operations, contact the nearest After
Sales Service Force. The After Sales Service spe-
cialist will carry out the reversibility of the doors at
your cost.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond to
your domestic power supply.
The appliance must be earthed. The power supply
cable plug is provided with a contact for this pur-
pose. If the domestic power supply socket is not
earthed, connect the appliance to a separate earth
in compliance with current regulations, consulting
a qualified electrician.
The manufacturer declines all responsibility if the
above safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
electrolux 33
16)
on the op-