Oase Vitronic 11 W Notice D'emploi page 15

Intended use
Vitronic, referred to as "unit", may only be used as specified in the following:
· For cleaning garden ponds.
· For operation with clean water.
· Operate in accordance with instructions.
The following restrictions apply to the unit:
· Never use the unit with fluids other than water.
· Never run the unit without water.
· Never operate the UVC lamp outside the casing or use it for any other purposes. The UVC radiation is harmful to the
eyes and skin even in small doses.
· Do not use for commercial or industrial purposes.
· Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
Installation and connection
Prerequisite
· The unit head is removed. (→ Dismantling the unit head)
Installing the unit
How to proceed:
5 B, C
· Install the unit at least 2 m from the edge of the pond.
· Only install the unit in the permitted positions to ensure fault-free operation.
· Allow sufficient space for carrying out maintenance work.
Establishing the connections
Use hoses that are suitable for a pressure of at least 1 bar.
How to proceed:
5 D
1. Shorten the stepped hose adapter to the diameter of the hose used if necessary.
– This reduces pressure losses.
2. Slip the hose clip over the hose, fit the hose onto the hose connector and secure with the hose clip.
– In the case of a stepped hose adapter with separate union nut, first push the union nut over the hose.
3. Connect the stepped hose adapter with seal to the casing.
– Connect the inlet and outlet.
– Hand tighten the stepped hose adapter.
Connect the unit to the flow-through filter.
Vitronic 18 W / 24 W / 36 W
The unit is suitable for connection to flow-through filters. Both outlet sockets are screwed to the inlet nozzles on the
flow-through filter. Adhere to the instructions for use of the flow-through filter.
How to proceed:
5 E
1. Unscrew the cover cap.
2. Guide the outlet sockets with flat seal through both holes in the container wall of the flow-through filter.
3. Screw the inlet nozzle with O ring onto the outlet socket and hand tighten.
4. Connect the supply hose to the inlet socket. (® Establish connections)
- EN -
15