Basic Operation; Turning The Radio On And Off; Adjusting The Volume; Selecting A Channel - Tait TM8100 Guide De L'utilisateur

Turning the
Radio On
and Off
Adjusting
the Volume
Selecting a
Channel
Making a
Call

Basic Operation

This section describes the basic operation of your radio,
including turning the radio on and off, adjusting volume,
selecting channels, making calls and receiving calls.
A long press of the on/off key
on or off. When the radio is first turned on, the red,
green and amber LEDs flash briefly and the radio gives
two short beeps.
Rotate the volume control clockwise to increase the
speaker volume and counterclockwise to decrease the
volume. The volume control also changes the volume
level of the radio's audible indicators.
Use the channel selection keys
through the channel list until the channel you want
is displayed.
1. Select the required channel or group using the chan-
nel selection keys
2. Check the green LED.
If the green LED is glowing, the channel is busy and
you cannot transmit.
3. Once the channel is clear (the green LED is off), lift
the microphone off the microphone clip.
4. Hold the microphone about 5cm (2 inches) from your
mouth and press the PTT key to transmit.
5. Speak clearly into the microphone and release the
PTT key when you have finished talking.
Note: You cannot change channels while
transmitting.
turns the radio either
or
or .
Basic Operation 11
to scroll