dji SNAIL Guide De L'utilisateur page 6

your PC using Snail ESC Programmer, it is possible
to set parameters and update firmware through DJI
Assistant 2.
Using ESC Programmer
430-R ESC
1. Download and install DJI Assistant 2 from the
Official DJI website.
(http://www.dji.com/snail/info#downloads)
2. Connect the ESC Programmer to the ESC with the
PWM signal cable and to your computer using
the USB cable on the programmer.
3. Connect a battery (3-4S LiPo) to supply power to
the ESC. Do not disconnect the ESC from your
computer or the power supply until configuration
is complete.
4. Launch DJI Assistant 2. When a connection is
4
ESC Programmer PC