Legal Obligations; Specific Information - KONG Italy MOUSE CLIMBING Mode D'emploi

4 – CHECKS AND INSPECTIONS
CS
We would strongly advise having checks before and after use, carried out by
qualified individuals, as indicated in the instructions for the specific equipment.
Except in the case of more stringent legal requirements, inspections on category III
equipment must be carried out by a competent person - therefore one trained and
DA
authorised by the manufacturer - every year starting from first use. The outcome of
these periodic inspections must be recorded on the equipment's inspection chart
or in a designated register.
5 – DEVICE LIFE
DE
Lifetime of metallic equipment is indefinable, theoretically unlimited, while those
in textile, synthetic or plastic is 10 years from the date of production, under the
following conditions:
EL
- The operating procedures comply with point 1C
- Maintenance and storage are carried out as described in point 3.
- The outcomes of pre- and post-use checks and routine inspections are positive.
- The equipment is used correctly, not exceeding ¼ of the marked load.
EN
Any equipment that do not pass the pre-use, post-use and periodic inspections
must be discarded.
6 – LEGAL OBLIGATIONS
Professional and recreational activities are often regulated by specific national
ES
laws that may impose specific limits and/ or requirements for the use of PPE and
the preparation of safety systems, which included the PPE in their components.
The user is obliged to know and apply these laws, which may in some cases
FI impose obligations different from those contained in this information.
7 – GUARANTEE
The manufacturer guarantees that the device complies with regulations in force
at the time of production. The guarantee covering faults is limited to production
FR
defects and raw materials. It does not include wear and tear, oxidation, damages
caused by improper use and/or during competition, incorrect maintenance,
transport, conservation, storage, etc. The guarantee becomes void as soon as
the device is modified or tampered with. The validity corresponds to the legal
IT
guarantee of the country where the device was sold by the manufacturer, with
effect from the date of sale. After this period no claim can be made against the
manufacturer. Any request for repair or replacement under this warranty must be
accompanied by a proof of purchase. If the defect is accepted, the manufacturer, at
NL
its sole discretion, will repair, replace or refund the device. Under no circumstances
does the manufacturer's liability extend beyond the invoice price of the device.
8 – SPECIFIC INFORMATION
PT
The helmet for mountaineering #997.160 - MOUSE CLIMBING (fig. 1) is a
category II personal protective equipment complying with the requirements set
forth in standard EN 12492:12 and to the UIAA Standard 106, and mainly designed
to protect the user from any dangers which might occur during mountaineering
RU
activities.
Important:
- the helmet is designed to absorb the energy of a shock through the destruction
or partial damage of the shell and / or webbings: replace the helmet even if the
SV
damage is not visible.
- do not modify your helmet and do not apply coatings, adhesives or solvents
different than those supplied by the manufacturer,