Device Life; Legal Obligations; Specific Information - KONG Italy MOUSE WORK Mode D'emploi

individuals, as indicated in the instructions for the specific equipment. Except in the
CS
case of more stringent legal requirements, inspections on category III equipment
must be carried out by a competent person - therefore one trained and authorised by
the manufacturer - every year starting from first use. The outcome of these periodic
inspections must be recorded on the equipment's inspection chart or in a designated
DA
register.
5 – DEVICE LIFE
Lifetime of metallic equipment is indefinable, theoretically unlimited, while those in
textile, synthetic or plastic is 10 years from the date of production, under the following
DE
conditions:
- The operating procedures comply with point 1C
- Maintenance and storage are carried out as described in point 3.
EL
- The outcomes of pre- and post-use checks and routine inspections are positive.
- The equipment is used correctly, not exceeding ¼ of the marked load.
Any equipment that do not pass the pre-use, post-use and periodic inspections must
be discarded.
EN
6 – LEGAL OBLIGATIONS
Professional and recreational activities are often regulated by specific national laws
that may impose specific limits and/ or requirements for the use of PPE and the
preparation of safety systems, which included the PPE in their components. The
ES
user is obliged to know and apply these laws, which may in some cases impose
obligations different from those contained in this information.
7 – GUARANTEE
The manufacturer guarantees that the device complies with regulations in force
FI
at the time of production. The guarantee covering faults is limited to production
defects and raw materials. It does not include wear and tear, oxidation, damages
caused by improper use and/or during competition, incorrect maintenance, transport,
FR
conservation, storage, etc. The guarantee becomes void as soon as the device is
modified or tampered with. The validity corresponds to the legal guarantee of the
country where the device was sold by the manufacturer, with effect from the date of
sale. After this period no claim can be made against the manufacturer. Any request
IT
for repair or replacement under this warranty must be accompanied by a proof of
purchase. If the defect is accepted, the manufacturer, at its sole discretion, will repair,
replace or refund the device. Under no circumstances does the manufacturer's
liability extend beyond the invoice price of the device.
NL
8 – SPECIFIC INFORMATION
MOUSE WORK (fig. 1) is a category II personal protective equipment complying
with the requirements set forth in standard EN 397:2012+A1:2012, and mainly
designed to protect the user from falling objects and brain injuries or skull fractures
PT
that might result. It is also suitable to be used at "very low temperatures", down to
-30°C.
Important:
RU
- The helmet is designed to absorb the energy of a shock through the destruction
or partial damage of the shell and / or webbings: replace the helmet even if the
damage is not visible.
- Do not modify your helmet and do not apply coatings, adhesives or solvents
SV
different than those supplied by the manufacturer,
- Always use original accessories and always apply them as recommended by the
manufacturer.