Maintenance And Storage - KONG Italy MOUSE WORK Mode D'emploi

I) Make sure that the device has been supplied complete, in its original packaging
and with the manufacturer's information. It is compulsory for dealers selling
products in countries other than the original destination to check and supply the
translation of this information.
L) All our equipment is tested/inspected piece by piece in accordance with the
procedures of the Quality System certified according to the UNI EN ISO 9001
standard. Our personal protective equipment is certified by the accredited authority
indicated in the equipment's specific instructions and, if they belong to category
III, are also subjected to production surveillance - in compliance with article 11/B
of Directive 89/686/CEE or with annex V and VIII of regulation 2016/425 - by an
authority whose accreditation number is indicated on the equipment.
Warning: laboratory tests, inspections, information and norms do not
always manage to reproduce what actually happens in practice, and so
performance under real usage conditions in a natural environment can
differ, sometimes even considerably. The best information can be gained
by continual practice under the supervision of skilled, expert, qualified
individuals.
2 – WORKS AT A HEIGHT
Additional information for protective equipment against falls from a height.
For the sake of safety in case of risk of falls from a height, it is essential to:
- assess the risks and make sure that the whole system, where this device is only a
component, is reliable and safe,
- prepare a rescue plan to deal with any emergencies possibly arising while the
device is being used,
- make sure that the anchoring device or the anchoring point is always positioned as
high up as possible, and that work is done in such way as to reduce potential falls
and relevant heights to a minimum,
- make sure that the devices used are suitable for the purpose and are certified.
Important: in a system for protection against falling from heights, it is obligatory to use
a complete harness in compliance with current regulations.
3 – MAINTENANCE AND STORAGE
Device maintenance consists of:
- Frequent washing in warm drinking water (30°C), possibly with the addition of
neutral detergent. Rinse and, without spinning, leave it to dry without leaving it in
the direct sunlight.
- Lubricate moving parts (only for metal devices) with silicon-based oil. This
operation is to be performed once the device has dried out, being careful to avoid
contact with textile components.
In addition, if necessary:
- disinfect the device, soaking it in warm water containing 1% of sodium
hypochlorite (bleach). Rinse with drinking water and, without spinning, leave it to
dry without leaving it in the direct sunlight. Avoid sterilising textile devices in an
autoclave.
Storage: store the devices in a dry (40-90% relative humidity), fresh (temperature
5-30°C) and dark place, chemically neutral (absolutely avoid salty and/or acid
environments), away from sharp edges, corrosive substances or other possible
detrimental conditions.
4 – CHECKS AND INSPECTIONS
We would strongly advise having checks before and after use, carried out by qualified
CS
DA
DE
EL
EN
ES
FI
FR
IT
NL
PT
RU
SV