BABYTREND HC57C Manuel D'instructions page 6

ASSEMBLY
TO ATTACH INSERT TRAY
• The dishwasher safe Tray Insert snaps
8)
onto the High Chair Tray and is held in
place by tabs on the sides of the Tray.
When installing the Tray Insert make
sure that it snaps into place to prevent
the child from removing the Tray Insert.
To remove Insert unsnap tabs from the
Tray (Fig. 8a).
• The Tray may be stored on the back
legs of the High Chair. Align the holes in
the rear of the tray with the small pegs
on the back legs (Fig. 8b).
11
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
TO USE SAFETY BELT
Fig. 8a
The Tray is not designed to hold the child in
the chair. Always keep child in view while in
high chair.
NEVER
Fig. 8b
9)
WARNING:
It is
recommended that only children
capable of sitting upright
unassisted use the high chair in
the upright position.
WARNING:
Prevent
serious injury or death from falls
or sliding out. Always secure
child in the restraint system,
either in the reclining, semi-
reclining or upright position.
leave child unattended.
• The shoulder straps of the 5-point
harness have 2 attachment positions.
Select the position that places the
shoulder strap level with, or below, the
top of the child's shoulder (Fig. 9a).
• Carefully place the child in the seat and
position the safety harness around the
child's waist and over the shoulders.
Place the crotch strap between the
child's legs. Insert the male end of each
shoulder/waist belt into the buckle on the
crotch strap. Tighten the harness to be
snug around the child's waist and over the
child's shoulders (Fig. 9b).
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
OPERATION
Fig. 9a
Adjust for a snug fit
Fig. 9b
12