BABYTREND HC57C Manuel D'instructions page 5

ASSEMBLY
TO ATTACH SEAT PAD
NOTE: Certain High Chair models are
packaged with the High Chair Seat Pad and
Seat Insert already attached to the Seat Back.
If your model has a Seat Pad and Seat Insert
on the Seat Back please skip ahead to Step 7.
• Thread non-buckle end of Harness Straps
5)
called Harness Attachment Tabs through
the provided slots in the body insert, seat
fabric, seat back (Fig. 5a), and seat base
(Fig. 5b). When Harness Attachment Tabs
are through the provided slots, rotate the
Harness Attachment Tabs 90 degrees.
Make sure that the straps are firmly in
place.
• Loop the flap on the back of the pad
6)
over the top of the Seat Back (Fig. 6a).
Connect the Seat Pad to the Seat Back
with the two Elastic Loops. These fit over
the Attachment Tabs located near the top
harness slots (Fig. 6b).
TO REMOVE SEAT PAD
Reverse steps above.
9
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
TO ATTACH TRAY
Fig. 5a
7)
Fig. 5b
ATTENTION:
Fig. 6a Never leave the tray in a position where the
warning signs are visible (Fig. 7b).
Fig. 6b
WARNING:
Always check
that the high chair is locked in
the open position before using.
WARNING:
The tray is not
designed to hold the child in the
chair. The child must be secured
by the safety harness at all times
while in the high chair.
• To attach the Tray, line up the Grooves
on the bottom of the Tray with the
armrests of the high chair. Squeeze the
front release handle and slide the Tray
onto the armrests (Fig. 7a). The Tray
has a 3-position adjustment. To adjust
the position, squeeze the front release
handle located underneath the Tray and
reposition the Tray to the desired position.
Release the Tray's handle. Make sure the
Tray is securely locked in its new position
before use.
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Release Handle
Groove
Fig. 7a
Fig. 7b
10