Lubricants; After Sales Support; Spare Parts; Rewinding - ABB HDP – IP54 Séries Manuel D'installation, D'exploitation Et De Maintenance

6.2.4 Lubricants

WARNING
Do not mix different types of grease.
Incompatible lubricants may cause damage to the

bearings.

All open bearings are greased in the factory with one of
the following types of grease:
- SKF LGMT3
- SKF LGHP2
"LGMT3" is lithium soap-mineral grease for high-tempera-
ture applications. Even if high-quality grease is used, its
properties deteriorate with time; therefore periodic regreas-
ing is required.
It is advised to use the same factory grease or another
with equivalent properties.
14 – EN ABB Motors and Generators | 9AKK105975, Rev. A 01-2015

7. After sales support

7.1 Spare parts

When ordering spare parts, the serial number of the motor
and its full type designation and product code, as stated
on the rating plate, must be specified.
For more information, please visit our web site at http://
online.abb.com/.

7.2 Rewinding

Rewinding should always be carried out by qualified repair
shops.
-HDP motors should not be rewound without first contact-
ing ABB.
7.3 Bearings
Special care should be taken with the bearings. These
must be removed using pullers and fitted by heating or
using tools designed for the purpose.