Electrolux EC3340AOW Notice D'utilisation page 13

Problem
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the ActionFreeze,
or after changing the tem‐
perature.
Temperature cannot be
set.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
The lamp is defective.
Temperature is set incor‐
rectly.
Large quantities of food to
be frozen were put in at
the same time.
The room temperature is
too high.
Food placed in the appli‐
ance was too warm.
The lid is not closed prop‐
erly.
The ActionFreeze function
is switched on.
This is normal, no error
has occurred.
The ActionFreeze function
is switched on.
The temperature regulator
is not set correctly.
The lid is not closed cor‐
rectly.
The products' temperature
is too high.
Many products are stored
at the same time.
The lid has been opened
often.
The ActionFreeze function
is switched on.
Products to be frozen are
placed too closely to each
other.
ENGLISH
Solution
Refer to "Replacing the
lamp".
Refer to "Operation" chap‐
ter.
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food to cool to room
temperature before storing.
Check if the lid closes well
and the gaskets are un‐
damaged and clean.
Refer to "ActionFreeze
function".
The compressor starts af‐
ter a period of time.
Refer to "ActionFreeze
function".
Set a higher/lower temper‐
ature.
Refer to "Opening and
closing the lid".
Let the product tempera‐
ture decrease to room tem‐
perature before storage.
Store less products at the
same time.
Open the lid only if neces‐
sary.
Refer to "ActionFreeze
function".
Make sure that there is
cold air circulation in the
appliance.
13