What To Do If; Environment Concerns; Packaging Material - ZANKER KEV6340FBB Notice D'utilisation

Masquer les pouces Voir aussi pour KEV6340FBB:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

What to do if...

Problem
You cannot activate the appliance
or operate it.
The appliance deactivates.
The residual heat indicator does not
comes on.
The sensor fields become hot.
comes on
and number comes on.
If you tried the above solutions and cannot repair the
problem, speak to your dealer or the customer service.
Give the data from the rating plate, three digit letter
code for the glass ceramic (it is in the corner of the
glass surface) and an error message that comes on.

Environment concerns

The symbol
on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it should be taken to the
appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential
negative consequences for the environment and human
health, which could otherwise be caused by
inappropriate waste handling of this product. For more
detailed information about recycling of this product,
18
Possible cause and remedy
• Activate the appliance again and set the heat setting in 10 seconds.
• You touched 2 or more sensor fields at the same time. Only touch one
sensor field.
• The Child Safety Device operates. See the chapter Operating instruc-
tions.
• There is water or fat stains on the control panel. Clean the control pan-
el.
You put something on the
The cooking zone is not hot because it operated only for a short time. If
the cooking zone should be hot, speak to the service centre.
The cookware is too large or you out it too near to the controls. Put large
cookware on the rear cooking zones if it is necessary.
The Automatic Switch Off operates. Deactivate the appliance and activate
it again.
There is an error in the appliance.
Disconnect the appliance from the electrical supply for some time. Discon-
nect the fuse from the electrical system of the house. Connect again. If
comes on again, speak to the service centre.
Make sure, you operated the appliance correctly. If not
the servicing by a customer service technician or dealer
will not be free of charge, also during the warranty peri-
od. The instructions about the customer service and
conditions of guarantee are in the guarantee booklet.
please contact your local council, your household waste
disposal service or the shop where you purchased the
product.

Packaging material

nents are identified by marking: >PE<,>PS<, etc. Dis-
card the packaging materials as household waste at the
waste disposal facilities in your municipality.
. Remove the object from the sensor field.
The packaging materials are friendly to the envi-
ronment and can be recycled. The plastic compo-

Publicité

Table des Matières
loading

Table des Matières