Mmi General Notes; Default Setting For Cleaning Sessions; Starting A Cleaning Session - Maytronics Wave 300 XL Instructions Pour L'utilisateur

5. mmi GeneraL noTeS

• In this user manual, the instruction press "Start" is performed by pressing both green buttons
-
• The MMI is equipped with a screensaver that comes into effect after 5 minutes idle time.
Press Pool and Home in that order to unlock the MMI console.
• Some options in the MMI menus are blocked by code, in order to prevent un-necessary changes
of settings. The code is the following key sequence:
3 2 1

6. DefauLT SeTTinG for CLeaninG SeSSionS

This section explains how to proceed to the default setting for a cleaning session. The robot is preset
in the factory with certain configurations that enable you to commence pool cleaning immediately.
The settings made during this setup session remain in use until changed by the operator.
To start a pool cleaning session directly after
you have assembled your Dolphin Wave,
proceed as follows:
1. Lift the MMI's protective cover.
2. Connect the robot's power supply to the main
power supply line.
3. Switch on the power supply. The MMI's Wave
screen (figure 8) opens in the home window.
4. Position the Caddy with robot about 0.5–1.0m
(1.5-3ft) from the pool's edge with its sloping
edge facing the swimming pool ensuring that
the floating cable is facing the direction of the
Dolphin Wave power supply unit.

Starting a cleaning session

25 30 35 40 50 60
set
figure 3: Pool Length Setup screen
Wave XL | User Instructions
-8151450_WAVE300XL_BOOK.indb 5
- simultaneously on the MMI console (Figure 2).
Pool Length Set Up
Meters
Remote
Control Unit
figure 2: The Dolphin Wave robot mmi console
1. On the MMI, press PooL. The robot will
start moving towards the pool, while pulling
the floating cable, and enter it and position
itself on the pool floor.
2. Wait for the WAVE screen to appear.
3. In every activation of the robot, it will
straighten itself vertically to the wall of the
starting point; the robot will start moving
ft.
backwards to straighten itself and then will
continue in straight lines.
back
4. Press Start. "Please select pool length" will
appear on the screen.
After 2 seconds the Pool Length Setup
screen appears.
Wave Keyboard
Home Buttons
Screen
5
1/27/14 2:48 PM