Maytronics Wave 300 XL Instructions Pour L'utilisateur page 13

manual procedure for configuring pool profiles
1. From the Wave screen, press menu.
2. From the Main Menu screen, with Pool
Profile highlighted, press Select and then
modify, to display the current active profile
screen.
3. Using the Select and scroll buttons
set each parameter in turn.
25 30 35 40 50 60
Set
figure 12: Pool length setup screen
7. Set each parameter and then scroll down to
the next line.
8. Set Pool Type and choose either Rectangular
(Default), or Shaped.
Rectangular - Recommended for pools with
parallel walls and 90º 'L' shape.
Shaped - Recommended for free formed
pools.
Lines to Left
Lines to Right
Set
figure 14: Scanning Direction screen
Wave XL | User Instructions
-8151450_WAVE300XL_BOOK.indb 11
 
Pool Length Set Up
Meters
ft.
Back
CrissCross Scanning
Back
Pool Length
Cycle Time
Pool Type
,
Scan Mode
Select
figure 11: Pool a menu: first screen
4. Press Select to enter the Pool Length Setup
screen.
5. With Pool Length highlighted, press Select.
The Pool Length Set Up screen is displayed:
6. Using the arrows
pool length. Press Select and scroll down to
the next parameter, Cycle Time .
Cycle Time determines the duration of each
cleaning cycle.
CrissCross
Lines to Scan
Pool with Obstacles
Set
figure 13: Scanning mode
9. Set Scan Mode and choose either CrissCross,
Lines to scan or Pool with Obstacles.
CrissCross - Recommended.
Lines to Scan - To be used when the pool
scan needs to be limited to one direction
or split into 2 sections.
Pool with Obstacles - To be used in pools
with an obstacle such as Island.
10. After choosing the "Scanning Mode"
you may choose the robot's progress
direction - "Lines to Left" or "Lines to Right".
Pool A Profil
25 m.
3 h.
Rect
Criscros R
Back
select the desired
 
Scannig Mode
Back
11
1/27/14 2:48 PM