Installer Le Receveur - Kohler Sterling 7224 Guide D'installation Et D'entretien

Masquer les pouces Voir aussi pour Sterling 7224:

Guide d'installation et d'entretien (32 pages)

Table Des Matières

Table des Matières

Install the Receptor (cont.)

Use a level to verify that the receptor is level and well supported by the ﬂoor. If

required, place shims under the receptor supports to level the receptor.

If the subﬂoor is not level or ﬂat and the receptor is not stable, consider installing

an optional mortar cement bed.

Install a Mortar Cement Bed (Optional)

Remove the receptor from the alcove.

NOTE: Do not use plaster, gypsum cement, or drywall compound for this

application, as they will not provide adequate structural support.

NOTE: The receptor supports must rest directly on the subﬂoor.

Spread a 1" (2.5 cm) layer of mortar cement on the subﬂoor, spreading it so that

each area of the receptor that will contact the subﬂoor has mortar cement. Do not

spread the mortar cement around the drain area. Allow room for the mortar

cement to expand from the weight of the receptor.

Immediately move the receptor into position.

Verify that the receptor is level and resting on all supports.

Clean the receptor to reduce the risk of damaging the surface.

Place a clean drop cloth or other similar material into the bottom and over the

outside edge of the receptor. Be careful not to scratch the surface of the unit.

Secure the Receptor

Verify the studs are within 1/8" (3 mm) of the receptor at the recommended

rooﬁng nail locations. Shim if necessary.

IMPORTANT! The plastic attachment clips provided must be used at each stud

location between the stud and tile ﬂange. The attachment clips will stabilize the

product and minimize noise.

At each stud location, position a plastic attachment clip over the top of the ﬂange.

Secure the attachment clip with a galvanized or plated screw or rooﬁng nail.