General Remarks - Diamond C4GF7-SP Instructions D'installation

- Carefully read the instructions contained in the present booklet as they supply important information
relating to safe installation, use and maintenance.
- Keep this booklet with care, for any further consultation by the various operators.
- Having removed the packing, make sure the unit is in good order and in case of doubt, do not use the unit, but
call on skilled personnel.
- Before connecting the unit, make sure the data appearing on the label correspond to those of the main gas supply.
- This unit must only be destined to the use it was expressely built for; any other use must be deemed improper
and therefore dangerous.
- The unit must be used only by a person trained for its operation.
- For any repairs, please call exclusively a technical service centre authorised by the manufacturer, and ask for
original spare parts only.
- The non-compliance of the above can compromise unit safety.
- Do not wash the unit with direct or high-pressure water jets.
- Do not obstruct openings or draft grids or heat vents.
FOR ELECTRICALLY POWERED UNITS:
- electrical safety is guaranteed only by an efficient earthing system, as envisaged by the electrical safety
regulation in force: it is therefore necessary to verify this essential requisite and, in case of doubt,
request an accurate check-up by professionally qualified personnel.
- the Manufacturer cannot be deemed responsible for any damages caused by the lack of earthing in the
system.
- the unit must be included in an equipotential system whose efficiency should be tested in compliance with the
law in force.
- all units are supplied with a 200cm long cable having a sufficient cross section for the maximum load.
- the hookup wire for the power supply connection should not have characteristics below the type with rubber
insulation H07RN-F
Do not wash the equipment with direct high-pressure water jets
MEASURES TO BE TAKEN WHEN THE EQUIPMENT IS NOT USED FOR A LONG TIME.
After cleaning the equipment well, wipe thoroughly all the steel surfaces with a cloth slightly soaked in
Vaseline oil and apply a thin protective coat.
IN CASE OF NON-COMPLIANCE WITH THE INDICATIONS CONTAINED IN THE PRESENT MANUAL, BOTH
ON THE USER'S PART AND ON THE INSTALLING TECHNICIAN'S PART, THE MANUFACTURER DECLINES
ANY ESPONSIBILITY, AND ANY POSSIBLE ACCIDENT OR FAULT CAUSED BY THE ABOVE MENTIONED
NON-COMPLIANCES WILL NOT BE IMPUTABLE TO THE MANUFACTURER.
THE MANUFACTURER DECLINES ANY RESPONSIBILITY FOR ANY IMPRECISIONS APPEARING ON THE
PRESENT BOOKLET, ASCRIBABLE TO TRANSCRIPTION OR PRINTING ERRORS. FURTHERMORE, THE
MANUFACTURER RESERVES THE RIGHT TO MAKE ANY MODIFICATIONS TO THE PRODUCT DEEMED
USEFUL OR NECESSARY, WITHOUT PREJUDICING ITS ESSENTIAL CHARACTERISTICS.

GENERAL REMARKS

- 19 -
GB