How To Make Cappuccino; Important - DeLonghi Bar 40 Mode D'emploi

bar 40 14-11-2001 14:14
the filter holder while the machine is dispensing
coffee.
7. To remove the used coffee, hold the filter locked
with the special lever that is built into the handle
and let the coffee fall out by knocking the
overturned filter holder (Fig. 12).
8 To switch off the coffee machine, turn the selector knob
on the appliance to the OFF position "O" (fig 13)
HOW TO PREPARE COFFEE USING THE FILTER
HOLDER FOR PODS (if fitted):
• Preheat the machine as described in the
'Preheating the Coffee Machine' section, making
sure to leave the filter holder attached to the unit.
Following this procedure ensures that the coffee is
delivered at a hotter temperature, as well as
guaranteeing that the seal of the filter holder
gaskets is more effective.
• Press the filter holder button and insert the pod into
the filter (fig 14).
Note: Use pods which conform to the ESE
standard: this will be indicated on the packaging
by the following symbol:
The ESE standard is a system accepted by the leading
coffee pod manufacturers, and allows espresso coffee
to be prepared simply and without any mess.
• Attach the filter holder onto the machine, moving
from left to right (fig 5).
If the waffle filter holder is used, after using the filter
holder for ground coffee, it is essential to first
remove any coffee grains (fig.24) that may have
stuck to the hot water drip spout. If this cleaning is
not done, water may exit from the sides of the
waffle filter holder while the coffee is being made.
• Proceed as in points 4, 5 and 6 in the previous
section on how to prepare espresso.
• To remove the pod, press the button on the filter
holder and simply lift the pod out
• To turn the coffee machine off, turn the selector knob
on the appliance to the Off position "O" (fig 13).
If you use the "iIIycaffe" coffee pods, use the special
filter holder. Insert the coffee pod ensuring the
name "iIIy" is facing down and the long side of the
pod is positioned as showned in figure.
Pagina 13

HOW TO MAKE CAPPUCCINO

1.Prepare espresso coffee, using cups that are large
2.Turn the selector knob to the
3.In the meantime, fill a container with approximately
4.Position the container with the milk in it under the
5.Immerse the cappuccino maker nozzle about 2 cm
6.Once the desired temperature has been reached (the
7.Pour the frothed milk into the cups containing the
IMPORTANT: always clean the milk frother and steam
nozzle immediately after use. Proceed as follows:
1.By turning the steam knob (fig. 17), allow a little
2.Hold the upper part tight with one hand and use your
enough for cappuccinos (see "How to prepare
espresso coffee).
The "cappuccino function" and "boiler on" red lights
will come on. Wait until the orange "OK" light comes
on, to indicate that the boiler has reached the ideal
temperature for producing steam.
3 fl. oz of milk for each cappuccino to be prepared.
The milk must be cold from the refrigerator (not
warm!). In choosing the container, bear in mind that
the volume of the milk will increase by 2 or 3 times.
Semi skimmed milk gives best results.
NOTE: We suggest you used semi-skimed milk at
refrigerator temperature.
milk frother (fig. 16).
deep into the milk and turn the steam knob in an
anti-clockwise direction (fig. 17) (by turning the knob
to a greater or lesser extent, it is possible to vary the
quantity of steam that comes out from the cappuccino
maker). At this point, the milk will begin to increase
in volume and to appear frothy.
ideal temperature is 60°C), stop the delivery of steam
by turning the steam knob in a clockwise direction
and at the same time positioning the selector knob at
"O" (fig. 13).
espresso coffee. Your cappuccino is now ready. Add
sugar to taste and, if desired, sprinkle a little
powdered chocolate on top of the froth.
steam to come out for a few seconds. Then close
firmly by turning clockwise.
other hand to unscrew the cappuccino maker,
position (fig. 15)
13