Removing The Transport Support; Rear Spacers - Electrolux EUF2947GOW Mode D'emploi

7.4 Removing the transport support

3

7.5 Rear spacers

7.6 Connecting the water hose.
Water supply should be provided with a
tap and 3/4" male connector within 1,5 m
from the appliance.
This work is to be carried out by a skilled
plumber.
There are different type-approved taps
and tap assemblies on the market.
The water hose must not be cracked,
squeezed or put in tight bends.
The safety valve provided in a package in-
side the appliance should be used to pre-
vent overflow.
Your appliance is equipped with transport
support to secure the door during trans-
portation.
To remove them do these steps:
• Open the door.
• Remove the transport support from the
door sides.
• Remove the transport support from the
lower hinge (some models).
Some models are fitted with a si-
2
lencing pad under the cabinet. Do
not remove this pad.
• Install the spacers provided within the
accessory bag as shown in the figure.
• Install the spacers on the brackets of
the condenser (black grill) at the back of
the appliance.
Before the safety valve is placed on the
tap, turn the pointer counter clockwise to
number 10 with the enclosed plastic key.
Install the safety valve on the tap and let
at least 10 litres of water flow through the
device.
Before connecting the appliance turn the
pointer to number 1 on the safety valve.
If the safety valve has shut off, detach it
and press the red plunger which is loca-
ted inside the lower housing of the device
itself.
Before the appliance is placed in final lo-
cation, ensure that the water connection
has been correctly carried out and that
ENGLISH 17