Operation; Arming The System; Instant-Arm Mode; Delay-Arm Mode - Honeywell FRIEDLAND FGGA04 Série Manuel D'installation Et D'utilisation

6

Operation

This section only describes the operation of the siren when operating without control panel (single zone).
6.1

Arming the system

When leaving the premises, the system must be armed. Make sure that the siren is in operating mode. Before arming the
system, make sure that all doors and windows are closed and that the available PIR movement detectors are not obstructed.
Make sure that animals are restricted to areas not protected by PIR movement detectors.
6.1.1

Instant-arm mode

The instant-arm mode will immediately arm the system. If the system is armed, activating any security detector will
immediately trigger an alarm. When entering the premises, disarm the system before opening any door or window protected
by a door/window contact detector or entering an area protected by a PIR movement detector. In the instant-arm mode, arm
and disarm the system from outside the premises using the remote control or the remote keypad.
1
Press the
The siren emits one beep. The indicators in the front lens and the learn indicator flash once.
6.1.2

Delay-arm mode

The delay-arm mode will arm the system with a 15-second entry/exit delay. The siren will emit one beep and another beep
after the 15-second delay has expired to allow time to leave the premises before the system is fully armed. When entering the
premises by opening any door or window protected by a door/window contact detector or entering an area protected by a PIR
movement detector, the system will be triggered and the siren will emit one long beep. However, the alarm will not sound until
the 15-second delay has expired. Disarm the system using the remote control or the remote keypad during the 15-second delay.
If an alarm occurs, the siren will sound continuously until the set alarm duration time expires. The alarm will stop and the
system will re-arm. The alarm lockout feature will prevent the system from re-arming after repeating the process three times.
1
Press the
After the 15-second delay has expired, the siren emits one beep. The indicators in the front lens and the learn
6.2

Disarming the system

1
Press the
Note: If the system is disarmed and the siren emits ten quick beeps, an alarm has been triggered while the system was
6.3

Personal attack facility

The user can trigger an alarm at any time in the event of threat or danger by activating the personal attack facility.
1
Press and hold the
Note: On earlier remote control models, slide the
personal attach switch.
6.4

Device tamper

If the battery cover of any device (except remote controls) is removed or if the siren or the remote keypad is removed from the
wall, an alarm will occur immediately even if the system is disarmed (unless the siren is in service mode). The alarm will sound
until the set alarm time expires or the system is disarmed from the remote control or the remote keypad.
Remote control
button.
Remote control
button.
indicator flash once to indicate the system is fully armed.
Remote control
button.
The siren emits two beeps.
Remote control
button for 3 seconds.
The alarm is triggered. The siren will sound.
Remote keypad
Enter the 4-digit ID code. Press the
Remote keypad
Enter the 4-digit ID code. Press the
Remote keypad
Enter the 4-digit ID code. Press the
armed.
Remote keypad
Press and hold the
9
button.
button or the
button.
button.
button or the button for
3 seconds.