EZA COMB-E Guide D'utilisation page 25

DC Charging
WARNING
Never use a damaged or frayed DC cord; electrical shock can occur if DC cord is damaged
or frayed. If DC cord is damaged, replace with a new cord before proceeding with DC usage
(request replacements via Contact Information on page 2).
Charging your unit :
1. Plug the provided Anderson extension cable into the back of the unit (see photo); then plug the
cable into the output of your charging source (for example, solar panel, hand crank, windmill, etc.).
2. While unit is charging, a flashing lightning bolt will appear in the top left-hand corner of the
LCD screen on the front of the unit.
3. Once the unit is fully charged, the lightning bolt will stop flashing and disappear completely.
All 6 bars of the battery indicator will be full.
4. Once the unit is fully charged, wait 10–15 minutes for the cells to settle. If you notice the battery
indicator drop down to 5 bars, reset the unit by pressing power key and then back power on the
unit. This will turn the charger back on so that it can fill up the balanced cells.
5. Once the unit is fully charged, power off the unit and disconnects the cables. Attention: This
unit will accept ONLY 12-volt DC sources. If any other VDC is used, the unit will be damaged.